2013年11月21日星期四

Install belt conveyor belt right steps

Whether replacing belt , or in a new drive to reinstall the belt , North camel recommend the following steps .
1 , turn off the power , drag chain conveyor remove the discharge guard , spin Song Mada mounting bolts. Move the motor to make enough slack belt without removing the belt can be forced open . Do

not pry off the conveyor belt !
2 , remove the old belt and check whether there is abnormal wear. Excessive wear may mean transmission on the design or maintenance problems .
3 , select the appropriate conveyor belt replaced.
4 , clean the roller chain conveyor conveyor belt and pulley , you should cloth stained with a little less volatile liquids wipe soaked in detergent or use a detergent scrub belts are undesirable ;

to remove oil and dirt , wipe with sandpaper or a sharp scraping objects , apparently also undesirable. Conveyor

The installation must be kept dry before use .
5, check whether there is abnormal wear and pulleys are in a straight line symmetry. A straight line symmetrical to the conveyor pulley drive operation is essential.
6 , check the other transmission parts, such as bearings and sleeve symmetry , durability, lubrication and so on.
7, in the installation of new conveyor pulleys , do not pry or excessive force.
8 , tighten the gear center distance until the tension belt tension measuring instrument properly measured so far. Hand turn laps driving wheel , retest tension .
9 Tighten motor mounting bolts to correct torque. Since turning device during operation center distance will result in any changes in conveyor poor performance , it is important

to ensure that all parts are tight turning device .
10 , although no longer need to adjust the belt tension , we still recommend starting device and observe the conveyor performance , to see whether there is abnormal vibration ,

listen for unusual noises. It is best to turn off the machine , check the bearings and motor status ; if feels too hot , it may be transported

Belt too tight , or bearing asymmetry, or incorrect lubrication .

没有评论:

发表评论