How to reduce the deviation phenomenon of belt conveyor

    Belt conveyor belt deviation runtime is the most common faults. To address such failures is important to note the dimensional accuracy of installation and daily maintenance.

There are several reasons for deviation, to be based on the difference between handling different reasons.

     1 Adjust the rubber belt conveyor idlers bearing belt in the middle of the entire belt conveyor idlers deviation, adjust the position to adjust the deviation; idlers in the

manufacture of both sides of the mounting holes are worked into holes in order to adjust . The specific method is biased which side of the belt, roller

Group toward which side of the belt forward direction forward, backward, or the other side. Belt upward direction of deviation is lower roller group should be at the left, the

upper roller group moved to the right place.

     2 Install the self-aligning roller group aligning roller group has a variety of types, such as intermediate shaft type, four-link, vertical roller, etc., the principle is

the use of block or roller rotates in the direction in the horizontal plane lateral thrust block or generate the Automatic belt adjustment belt deviation reaches to the heart of

the purpose. General

The total length of the belt conveyor belt conveyor shorter or bidirectional operation using this method is more reasonable, because the shorter belt conveyor easier deviation

and not easy to adjust. And long Incline Belt conveyor is best not to use this method because the group aligning roller belt use would make

Useful life of a certain impact.

     3 Adjust the drive pulley and the driven pulley and bend pulley position adjustment bend pulley belt deviation adjustment is an important part. Because at least a belt

conveyor rollers 2 to 5, the installation location of all rollers of the belt conveyor must be perpendicular to the longitudinal direction of the center line,

If the skew is too large deviation bound to happen. Adjustment Method and its group of similar idlers. For the head drum as the drum belt deviation to the right, the right of

the bearing should be moved forward, the belt deviation to the left of the drum, the left bearing housing should be moved forward, also the corresponding

You can move left or right rear bearing housings after the shift. Rear roller adjustment method and the head drum opposite. After repeated adjustments until the belt transferred

to an ideal location. Adjust the drive or bend pulley in the best pre-install its exact location.